DALI-2 ROT Touch
L4: RGB and scenes

DALI-2 ROT Touch
L3: Tunable White und Szenen

DALI-2 ROT Touch
L2: groups, scenes and blinds

DALI-2 ROT Touch
L1: groups and scenes

DALI-2 ROT NFC
DALI ROT is a rotary knob basis to control the light level of DALI luminaires.

DALI-2 ROT Integration
DALI-2 ROT Integration is a rotary and push button for integration into higher-level building management systems (WAGO, Beckhoff, LUNATONE DALI-2 KNX gateway).

DALI-2 CS Integration THP-AQ LE
for Integration in systems with central control units
sensor for motion, light, temperature, relative humidity, air pressure and air quality

DALI-2 CS Integration THP LE
for Integration in systems with central control units
sensor for motion, light, temperature, relative humidity & air pressure

DALI-2 CS Corridor Integration
Compact DALI-2 sensor module for Integration in systems with central control units
sensor for motion detection (PIR) & light intensity

DALI-2 CS Mini Integration
Compact DALI-2 sensor module for Integration in systems with central control units
sensor for motion detection (PIR) & light intensity

Phase dimmer with DALI input to control dimmable 230V luminaires in a DALI system. Available for leading edge, trailing edge or as universal device with automatic load detection. Available as compact 25W version or as 300W version. From Firmware 3.5 onwar

Phase dimmer with DALI input to control dimmable 230V luminaires in a DALI system. Available for leading edge, trailing edge or as universal device with automatic load detection. Available as compact 25W version or as 300W version. From Firmware 3.5 onwar

DALI-2 IoT Gateway is an interface to connect the DALI system with smart devices over the Internet of Things (IoT). With the DALI IoT Gateway, a simple realization of an intelligent system is possible, in which devices can be controlled and monitored with

DALI LED-driver (CV) with 4 channels to control RGB or RGBW luminaires via one DALI address (DT8). As alternative to the DT8 control the device also supports the operating modes Colour&Dim and SwitchDim2 (control via 2 switch inputs without DALI). Availab

This compact module converts 0-10V input voltages into DALI light levels. Configurations can be made using the DALI Cockpit software. Target address and dimming characteristic can be configured.

Pushbutton coupler with 4 inputs to connect standard potential-free switches or pushbuttons. New functions, DALI-2 and NFC configuration!

The DALI USB is used as interface between the DALI Cockpit PC Software and the devices on the DALI bus. It enables the addressing and configuration of DALI installations. The DALI USB is available in 6 different versions: with strain relief, for DIN Rail

DALI LED-driver. Input voltage 230VAC, output with secure isolation between mains and DALI. Output signal can be controlled via DALI or SwitchDim2.
Versions for constant current (250mA/350mA … 1050mA) and constant voltage (24V, 1A max.) are available.

DALI RM8 provides a via DALI bus controllable relay switch, which allows direct switching of permanent loads up to 2kW. Various compact designs and variations with make contact or changeover contact are available. The purposeful switching in voltage zero

Interface wirelessly connected to the DALI line. This battery powered wDALI module has four individually configurable switch inputs. The device can be mounted anywhere within the reception range of the receiver, which has to be connected to the DALI line.